Material: 100% Nitrile (NBR) (Black) manufactured to SAE J20 standards. 
Operating Temperatures: -40°F to 248°F (-20°C to 120°C)
Use: Air Intake Systems

LUCKEY SAYS: Our 90 degree Nitrile air intake hoses are a quality replacement for old OEM intake hoses. Rubber OEM hoses can become dried, cracked and can disintegrate over time making them less than airtight. This can result in reduced engine performance, reduced gas mileage and could result in debris entering the engine of your car which can cause serious damage. Made from Nitrile, these hoses will stand the test of time and are covered by our million-mile warranty.

LUCKEY TIP 1: On Nitrile HoseTechniques degree hoses, the leg lengths are measured by drawing a center line (down the very center of the hose) and noting the point where the two center lines intersect. From this point to the end of the leg is the measuring point for the leg length. In the part number, the third set of digits identifies the leg lengths.

LUCKEY TIP 2: Ensure you use quality clamps such as our 100% stainless steel clamps to reduce the possibility of air leakage. Avoid using worm clamps as they can tear and contort the Nitrile, which will cause damage to the hose.