Material: Premium Silicone Compound / Nomex®
(Aramid) multi-ply reinforcement
Manufactured to SAE J20 standards.
Note: Not intended for any fuel, oil or oil by-products.
Operating Temperatures: -65°F to 500°F (-54°C to 260°C)
Use: Turbochargers, superchargers,
intercoolers, air intakes and other engine components
LUCKEY SAYS: 30 degree elbow transitions are extremely
useful for the engine builder who needs to connect two different diameter pipes
that are positioned at a 30 degree angle from each other.
LUCKEY TIP: On standard HoseTechniques degree
hoses, both legs are equal length. The
leg length is measured by drawing a center line (down the very center of the
hose) and noting the point where the two center lines intersect. From this point to the end of the leg is the
measuring point for the leg length. In
the part number, the third set of digits identifies the leg lengths (i.e. in
this part number: 53T.300/350-346-xxx, 346 is the leg length which means
it is 3.46 inches long on both legs).